|
|
| |
0 of 0 people found the following review helpful: |
| |
 |
 |
 |
|
MUST HAVE MOTORS!! |
February 19, 2010 |
| Reviewer:
Anonymous person
from Orange County, CA United States
|
|
Wow! What a difference these motors make to a BCX2 heli. I broke these motors in prior to installation, and the difference of power from stock was just amazing. A must purchase for other R/C heli enthusiasts.
Was this review helpful to you? 
|
|
 |
|
 |
|
| |
0 of 0 people found the following review helpful: |
| |
|
|
|
|
|
Fantastic Upgrade |
January 26, 2010 |
| Reviewer:
Patrick Clark
from Lafayette, CO United States
|
|
I just installed these after trying the aeronutz motors. Boulder is a mile high and the air is a bit thin. What a difference! I'm seeing half throttle flights and 1.5 durations over the old motors. Try the boomtown body/tail kit to bring it outdoors too. Great Upgrades.
Was this review helpful to you?
|
|
|
|
|
|
| |
0 of 0 people found the following review helpful: |
| |
|
|
|
|
|
What a difference these make! |
December 12, 2009 |
| Reviewer:
James Lyons
from San Jose, CA United States
|
|
Talk about night and day performance increase. Be careful (you will smack the ceiling) until you get use to the power of these motors. Great for outdoor use along with boom tail.
Was this review helpful to you?
|
|
|
|
|
|
| |
2 of 2 people found the following review helpful: |
| |
|
|
|
|
|
A Must Upgrade! |
April 23, 2009 |
| Reviewer:
Paul Koch
from Carlsbad, CA United States
|
|
I installed these motors with no problems and the power I got from these bad boys is fantastic. When I push the stick forward and throttle up my CX2 cuts through 10mph winds like nothing. These motors run so much cooler than the stock ones too. I recommend upgrading to these.
Was this review helpful to you?
|
|
|
|
|
|
| |
2 of 2 people found the following review helpful: |
| |
|
|
|
|
|
Great upgrade, especially for adding a camera |
January 16, 2009 |
| Reviewer:
Benjamin Del Vacchio
from Audubon, PA United States
|
|
I found that my stock CX2 could just barely hold a flycamone2. Got these, broke these in, installed them on a new CNC body (and battery tray) with some ultraflex skids, and it can now handle the weight of the camera without struggling! Just be careful when you're installing them, the stronger magnets tend to pick up stray screws.
Was this review helpful to you?
|
|
|
|
|
|
|
